A scuba tank carrier by Shark Bite Scuba®

image90

image91

The Tank Dolly® transports 4 fins ⏤ just add the Fin Holder

Fin Holder: Top component

  • The 1H x 21L x 5W (2.5H x 53.3L x 12.7 cm) bracket bolts to the rear of the Tank Brace

  • Use the top 2 reciprocal 0.25 inch (0.6 cm) holes on the Tank Brace to secure the top bracket

  • (2) 0.25 inch (0.6 cm) stainless-steel bolts and lock nuts are included  


Sharp Tip:

  • The bottom 2 holes in the Tank Brace should not be used to secure the Fin Holder

  • However, the holes may be used as a bungee cord anchor point

image92

Fin Holder: Bottom component

The 4H x 19L x 2W inch (10.1H x 48.2L x 5W cm) component attaches to the Weight Box Gusset

  • The 4H x 19L x 2W inch (10.1H x 48.2L x 5W cm) component attaches to the Weight Box Gusset

  • Use the 2 reciprocal 0.25 inch (0.6 cm) holes on the Gusset to secure the Fin Holder's bottom component

  • (2) 0.25 inch (0.6 cm) stainless-steel bolts and lock nuts are included

🇺🇸The Fin Holder is Made in the USA

The Fin Holder is constructed from marine grade 5052-H32 aluminum and is powder-coated for an extra layer of protection.

image93

How to use the Fin Holder

Place the fins' blades through the top bracket and into the bottom component of your Fin Holder

  • Fins with a steep blade angle should be inserted with the fins' bottom surface facing toward the front of your Tank Dolly®

  • Place your Weight and Tank(s) on The Tank Dolly® before inserting the fins into the Fin Holder

The 10-year limited warranty covers 100% of the Fin Holder